The is a versatile, all-in-one programmer and debugger designed by Infineon Technologies (formerly Cypress Semiconductor). It serves as a critical bridge between a PC and PSoC devices, allowing developers to program, debug, and test firmware across nearly the entire PSoC portfolio. Key Capabilities
🛠 If you see "device not recognized," try forcing the driver to Cypress Generic USB Serial in Device Manager.
: Beyond programming, it functions as a bridge to interface a PC with PSoC devices for real-time tuning and debugging of I2C-based sensors or peripherals. psoc miniprog3
The PSoC Miniprog3 is a powerful tool for programming and debugging PSoC devices. By following this guide, you should be able to set up and use the Miniprog3 with ease. If you encounter any issues, refer to the troubleshooting section or consult the documentation for the PSoC Creator or PSoC Designer software.
The CY8CKIT-002 PSoC MiniProg3 is an all-in-one programmer and debugger designed for Cypress Semiconductor (now Infineon Technologies) Programmable System-on-Chip (PSoC) architectures. It acts as a bridge between a development PC and a target PSoC device, facilitating firmware downloads, real-time debugging, and hardware communication verification. Engineering teams widely utilize it for complex prototyping, sensor data acquisition, and medical or industrial telemetry testing. Core Features and Architecture The is a versatile, all-in-one programmer and debugger
The MiniProg3 is often cited as a more cost-effective alternative to high-end probes like the Atmel-ICE or Microchip ICD4, while providing better performance than entry-level evaluation board programmers. It is available through major electronics distributors like RS Components and DigiKey .
The 10-pin interface expands capabilities to encompass JTAG, SPI, and full I2Ccap I squared cap C master functionality. Pin Number Signal Name Pin Number Signal Name STEST / SCLK SCLK / SWDCLK MISO / SDA SDATA / SWDIO MOSI / SCL NC (No Connect) Practical Troubleshooting Guide : Beyond programming, it functions as a bridge
: Older hardware revisions (Revision *B or older) do not support programming the eFuses of PSoC 6 devices.
It bridges the host computer to standard serial communication protocols including Serial Wire Debug (SWD), Joint Test Action Group (JTAG), Inter-Integrated Circuit ( I2Ccap I squared cap C ), and Serial Peripheral Interface (SPI).